Wheel Bearing End Play Check

WHEEL BEARING END PLAY CHECK

1. Remove the brake caliper assembly, and suspend the brake caliper assembly with a wire and remove the brake disc (Refer to Rear Axle).





2. Check the bearing's end play. Place a dial gauge against the hub surface; then move the hub in the axial direction and check whether or not there is end play.
Limit: 0.05 mm (0.002 inch)
3. If the play exceeds the limit, replace the rear hub assembly.
4. After having finished the inspection, install the brake disc, brake caliper assembly and tighten the brake caliper assembly mounting bolts to the specified torque (Refer to Rear Axle).