Cruise Control Switch: Testing and Inspection

AUTO-CRUISE CONTROL SWITCH CHECK

AUTO-CRUISE CONTROL MAIN SWITCH CHECK

1. Turn the ignition switch to the "ON" position.





2. Check that the "CRUISE" indicator light within the combination meter illuminates when the "CRUISE" (MAIN) switch is switched "ON".

AUTO-CRUISE CONTROL SETTING

1. Switch "ON" the "CRUISE" (MAIN) switch.

2. Drive at the desired speed, above approximately 40 km/h (25 mph).





3. Push the auto-cruise control switch in the direction of the arrow.
4. Check to be sure that when the switch is released the speed is the constant speed.
NOTE:
If the vehicle speed decreases to approximately 15 km/h (9 mph) below the set speed because of climbing a hill for example, it is normal for the auto-cruise control to be cancelled.

SPEED-INCREASE SETTING

1. Switch "ON" the "CRUISE" (MAIN) switch.

2. Set to the desired speed, above approximately 40 km/h (25 mph).





3. Push the auto-cruise control switch in the direction of the arrow.
4. Check to be sure that acceleration continues while the switch is held, and that the speed at the time it was released becomes the constant driving speed.
NOTE:
Acceleration can be continued even if the vehicle speed has passed the high-speed limit [approximately 200 km/h (124 mph)]. But the constant driving speed when the auto-cruise control switch is released will be recorded as the high-speed limit.

SPEED-REDUCTION SETTING

1. Switch "ON" the "CRUISE" (MAIN) switch.

2. Set to the desired speed, above approximately 40 km/h (25 mph).





3. Push the auto-cruise control switch in the direction of the arrow.
4. Check to be sure that deceleration continues while the switch is pressed, and that the speed at the time it was released becomes the constant driving speed.
NOTE:
When the vehicle speed reaches the low limit [approximately 40 km/h
(25 mph)] during deceleration, the auto-cruise control will be cancelled.

RETURN TO THE SET SPEED BEFORE CANCELLATION AND AUTO-CRUISE CONTROL CANCELLATION

1. Switch "ON" the "CRUISE" (MAIN) switch.

2. Set to the desired speed, above approximately 40 km/h (25 mph).





3. When any of the following operations are performed while at constant speed during auto-cruise control, check if normal driving is resumed and deceleration occurs.
(1) The auto-cruise control switch is pulled in the direction of the arrow.
(2) The brake pedal is depressed.
(3) The selector lever is moved to the "N" range.
4. At a vehicle speed of 40 km/h (25 mph) or higher, check if when the "ACC/RES"
switch is switched ON, the vehicle speed returns to the speed before auto-cruise control driving was cancelled, and constant speed driving occurs.
5. When the "CRUISE" (MAIN) switch is turned to the "OFF" while driving at constant speed, check if normal driving is resumed and deceleration occurs.