Inspection Procedure 4

INSPECTION PROCEDURE 4: Jumps Out of Gear

DIAGNOSIS

STEP 1. Check the transaxle control

Q. Are the shift cable and the select cable in good condition?

YES Go to Step 2.

NO Repair or replace the shift cable and the select cable (Refer to Service and Repair).
Then go to Step 6.

STEP 2. Remove and disassemble the transaxle. Check the poppet spring [5M/T]
or lock ball assembly [6M/T] for breakage.

Q. Is the poppet spring or lock ball assembly broken?

YES Replace the poppet spring Disassembly and Assembly) [5M/T] or the lock ball assembly ) [6M/T].
Then go to Step 6.

NO Go to Step 3.

STEP 3. Check the control housing [5M/T] or selecting bell-crank assembly and control bell-crank dust cover and the shift and select lever shaft [6M/T].

Q. Is the control housing in good condition?

YES Go to Step 4.

NO Repair or replace the control housing Disassembly and Assembly) [5M/T]
or the selecting bell-crank assembly and control bell-crank dust cover and the shift and select lever shaft ) [6M/T].
Then go to Step 6.

STEP 4. Check the gear shift forks for wear.

Q. Is the gear shift forks worn?

YES Replace the gear shift fork Disassembly and Assembly [5M/T] or Transaxle [6M/T]). Then go to Step 6 .

NO Go to Step 5.

STEP 5. Check the clearance.

Q. Is the clearance between the synchronizer hub and sleeve excessive?

YES Replace the synchronizer hub or sleeve Disassembly and Assembly, Output Shaft Disassembly and Assembly [5M/T] or Output Shaft , [6M/T]).
Then go to Step 6.

NO Go to Step 6.

STEP 6. Check trouble symptoms.

Q. Does the transaxle still jumps out of gear?

YES Return to Step 1.

NO This diagnosis is complete.