Front Axle

WHEEL BEARING END PLAY CHECK

1. Remove the brake caliper assembly and brake disc, and retain the brake caliper assembly with a wire and the like to prevent from falling (Refer to Removal and Replacement).





2. Set a dial gauge as shown in the figure. Move the hub in the axial direction and measure the end play.
Limit : 0.05 mm (0.002 inch)
3. If the play exceeds the limit, disassemble hub knuckle assembly to check each component.
If the wheel bearing is faulty, replace it (Refer to Front Axle Hub Assembly Disassembly and Reassembly).
4. After checking, install the brake disc and the brake caliper assembly (Refer to Removal and Replacement).