Crankshaft Main Bearing: Specifications

Crankshaft Bearing Cap Bolts

Inspection





Measure the 2 points on outside diameter of thread as shown in illustration
When difference between measured outside diameters is beyond limit value, replace the bolt
Limit value
M10 0.15 mm (0.006 inch)
M8 0.10 mm (0.004 inch)

Tightening Torque





M10 37.2 ± 2.0 Nm (27 ± 1 ft-lb)
M8 9.0 ± 2.0 Nm (80 ± 17 in-lb)
All bolts in sequence Tighten 90°

Main Bearing Size Codes

Upper





When replacing the crankshaft bearing upper, select a bearing with the size corresponding to the crankshaft journal diameter in the table below





The crankshaft bearing upper has an identification color at the illustrated position





Install the selected crankshaft bearing upper

Lower





When replacing the crankshaft bearing lower, select a bearing with the size corresponding to the crankshaft journal diameter in the table below





The crankshaft bearing lower has an identification color at the illustrated position
Install the selected crankshaft bearing lower





Crankshaft Journal Oil Clearance
Standard value
No. 1, 2, 4, 5 0.039 - 0.065 mm (0.0015 - 0.0026 inch)
No. 3 0.051 - 0.077 mm (0.0020 - 0.0030 inch)
Limit 0.10 mm (0.004 inch)

Crankshaft End Play
Standard value 0.05 - 0.25 mm (0.002 - 0.010 inch)
Limit 0.4 mm (0.02 inch)