Procedures

INSPECTION

SEAT BELT WITH PRE-TENSIONER CHECK

WARNING:

- If any component damage is found during the following inspection, replace the seat belt with pre-tensioner with a new one. Dispose of the old one according to the specified procedure (Refer to Procedures ).
- Never attempt to measure the circuit resistance of the seat belt pre-tensioner even if you are using the specified tester. If the circuit resistance is measured with a tester, accidental seat belt pre-tensioner operation will result in serious personal injury.

1. Check seat belt pre-tensioner for dents, cracks or deformation.

2. Check the connectors for damage, the terminals for deformation, and the harness for binding.