Cylinder Head Assembly

CAUTION
Attach the head bolt washer in the direction shown in the figure.





Tighten the bolts in the illustrated sequence in two or three steps.

Tightening torque 108± 5Nm (80± 4 ft-lb)
Back off the bolts once and tighten them again to the specified torque in step1.

Cylinder Head Flatness of Gasket Surface
Standard Value Less than 0.03 mm (0.001 in)
Limit 0.2 mm (0.007 in)

Cylinder Head Grinding Limit of Gasket Surface (Total resurfacing depth of cylinder head and cylinder block)
Limit 0.2 mm (0.007 in)

Cylinder Head Overall Height
Standard Value 120 mm (4.7 in)

Intake Manifold Specifications

Exhaust Manifold Specifications

Camshaft Gear/Sprocket Specifications