Inspection Procedure 5

INSPECTION PROCEDURE 5: Selector Lever cannot be Moved from "R" to "P" Position.

TECHNICAL DESCRIPTION (COMMENT)

Selector lever assembly, transaxle control cable, or lock cam may be defective.

TROUBLESHOOTING HINTS

- Malfunction of selector lever assembly
- Malfunction of transaxle control cable
- Malfunction of lock cam

DIAGNOSIS

STEP 1. Check the connection of selector lever assembly and transaxle control cable.

Q. Is the connection of selector lever assembly and transaxle control cable in good condition?

YES Go to Step 2.

NO Repair the connection of selector lever assembly and transaxle control cable. Check that the selector lever can be moved from "R" position to "P" position.

STEP 2. Check the fit of the lock cam.

Q. Is the lock cam installed correctly?

YES Go to Step 3.

NO Install the lock cam correctly. Check that the selector lever can be moved from
"R" position to "P" position.

STEP 3. Check the lock cam.

Q. Is the lock cam in good condition?

YES Go to Step 4.

NO Replace the selector lever assembly. Refer to Service and Repair.
Check that the selector lever can be moved from "R" position to "P" position.

STEP 4. Check the fit of the transaxle control cable.

Q. Is the transaxle control cable installed correctly?

YES Go to Step 5.

NO Install the transaxle control cable correctly. Refer to Service and Repair.
Check that the selector lever can be moved from "R" position to "P" position.

STEP 5. Check the transaxle control cable.

Q. Is the transaxle control cable in good condition?

YES Repair or replace the selector lever assembly. Refer to Service and Repair.
Check that the selector lever can be moved from "R" position to "P" position smoothly.

NO Replace the transaxle control cable. Refer to Service and Repair.
Check that the selector lever can be moved from "R" position to "P" position.