Removal and Replacement

REMOVAL AND INSTALLATION

CAUTION:

- Do not replace the ECM [M/T] or PCM [A/T] and the ETACS-ECU simultaneously. Always replace either one of the ECUs first, and register the encrypted code Immobilizer System ). Then, replace the other ECU.
- After the ECM [M/T] or PCM [A/T] is replaced, idling speed may be unstable because the MFI engine learning is not completed. To make it stable, make the system learn the idling Learning Procedure for Idling in MFI Engine ).





[VEHICLES FOR USA]










[VEHICLES FOR CANADA]






REMOVAL SERVICE POINT

[[A]] BREAK-OFF BOLTS REMOVAL





1. Drill in the break-off bolt a hole deep enough for the tap to stand.
2. Remove the break-off bolt with a left-hand tap.

INSTALLATION SERVICE POINTS

]]A[[ BREAK-OFF BOLTS INSTALLATION

Tighten until the head of break-off bolt is broken off.

]]B[[ INITIALIZATION PROCEDURE

Turn the ignition switch on then off, and keep it off for at least 10 seconds.