Accelerator Pedal Position Sensor: Service and Repair
ACCELERATOR PEDALREMOVAL AND INSTALLATION
CAUTION:
- Never loosen the screw fixing the accelerator pedal assembly resin cover. If the screw is loosened, the sensor position which exists inside the resin cover is off and the accelerator pedal position sensor does not work normally.
- Do not remove the accelerator pedal pad. If the pad is removed and installed, excessive force may damage accelerator pedal position sensor.
INSTALLATION SERVICE POINT
]]A[[ ACCELERATOR STOPPER INSTALLATION
1. Insert the accelerator stopper straight into the stud bolt of the floor.
2. Install the accelerator stopper securely by turning it clockwise until its underside contacts with the body bracket as shown in the figure.
3. After the installation, slightly pull the accelerator stopper by hand to check that it cannot be removed easily (appropriate holding power: 100N or more).