C1361

DTC C1361: M/C pressure SNSR. stuck/low gain
DTC C1364: M/C pressure SNSR. malfunction

CAUTION:
If there is any problem in the CAN bus lines, an incorrect diagnostic trouble code may be set. Prior to this diagnosis, diagnose the CAN bus lines.

CAUTION:
Whenever the ECU is replaced, ensure that the CAN bus lines are normal.

CIRCUIT OPERATION

The master cylinder pressure sensor is incorporated in the hydraulic unit. When the brake pedal is depressed, the sensor detects the fluid pressure in the master cylinder, and converts it to voltage signal.

TCL/ASC DTC SET CONDITIONS

This DTC is set if the master cylinder pressure sensor is defective.

TROUBLESHOOTING HINTS (The most likely causes for these DTCs are to set are:)

- The CAN bus line is defective.
- Malfunction of the hydraulic unit (integrated with TCL/ASC-ECU)

DIAGNOSIS

Required Special Tools:

- MB991958: Scan Tool (M.U.T.-III Sub Assembly)
- MB991824: Vehicle Communication Interface (V.C.I.)
- MB991827: M.U.T.-III USB Cable
- MB991910: M.U.T.-III Main Harness A

STEP 1. Using scan tool MB991958, diagnose the CAN bus line.





CAUTION:
To prevent damage to scan tool MB991958, always turn the ignition switch to the "LOCK" (OFF) position before connecting or disconnecting scan tool MB991958.

(1)Connect scan tool MB991958 to the data link connector.
(2)Turn the ignition switch to the "ON" position.
(3)Diagnose the CAN bus line.
(4)Turn the ignition switch to the "LOCK" (OFF) position.

Q. Is the CAN bus line found to be normal?

YES Go to Step 2.

NO Repair the CAN bus line CAN Bus Diagnostics Chart).
Then go to Step 2.

STEP 2. Recheck for diagnostic trouble code.





CAUTION:
To prevent damage to scan tool MB991958, always turn the ignition switch to the "LOCK" (OFF) position before connecting or disconnecting scan tool MB991958.

(1)Turn the ignition switch to the "ON" position.
(2)Erase the DTC.
(3)Turn the ignition switch to the "LOCK" (OFF) position.
(4)Turn the ignition switch to the "ON" position.
(5)Check if the DTC is set.
(6)Turn the ignition switch to the "LOCK" (OFF) position.

Q. Is DTC C1361 or C1364 set ?

YES Replace the hydraulic unit (integrated with TCL/ASC-ECU).

NO The procedure is complete.