Ignition Switch: Service and Repair

REMOVAL AND INSTALLATION

CAUTION
- Before removing the steering wheel and driver's air bag module assembly, refer to Service Precautions and Driver's Air Bag Module and Clock Spring [GTS] or [RALLIART] [Vehicles with WCM].
- After the installation, perform a calibration for the ASC-ECU to learn the steering wheel sensor neutral point (Refer to On-vehicle Service -Steering Wheel Sensor Calibration). [Vehicles with WCM and ASC]

Pre-removal & Post-installation Operation:

Removal Steps 1-10 (Part 1):

Removal Steps 1-10 (Part 2):

REMOVAL SERVICE POINT

]]A[[ STEERING LOCK CYLINDER REMOVAL [VEHICLES WITH WCM]

1. insert the key into the steering lock cylinder, and turn the ignition key to the acc position.







2. with using a cross-headed screw driver (small) or similar items to press in the lock pin, remove the ignition key, and then remove the steering lock cylinder.

INSTALLATION SERVICE POINT

]]A[[ WIRELESS CONTROL MODULE [VEHICLES WITH WCM]/RECEIVER ANTENNA MODULE [VEHICLES WITH KOS] INSTALLATION

check that the top claw of receiver antenna module is fixed securely to the boss of steering lock and the antenna is not floated on the key cylinder.