Twin Clutch-Sportronic Shift Transmission (TC-SST)

DTC P0630: VIN not Recorded

CAUTION
^ If there is any problem in the CAN bus lines, an incorrect diagnostic trouble code may be set. Prior to this diagnosis, diagnose the CAN bus lines.
^ Whenever the ECU is replaced, ensure that the CAN bus lines are normal.

DIAGNOSTIC FUNCTION
TC-SST-ECU checks that the chassis number is normal.
(TC-SST-ECU receives chassis number information from the engine control module via CAN, and write to TC-SST-ECU.)

DESCRIPTIONS OF MONITOR METHODS
The chassis number is determined to be written abnormally.

PROBABLE CAUSES
^ The CAN bus line is defective.
^ Malfunction of engine control module
^ Malfunction of TC-SST-ECU

DIAGNOSTIC PROCEDURE

Required Special Tools:
^ MB991958 Scan Tool (M.U.T-III Sub Assembly)
^ MB991824: Vehicle Communication Interface (V.C.I.)
^ MB991827 M.U.T-III USB Cable
^ MB991910 M.U.T-III Main Harness A

STEP 1. Scan tool CAN bus diagnostics
Using scan tool MB991958, diagnose the CAN bus lines.
Q: Is the check result normal?
YES: Go to Step 2.
NO: Repair the CAN bus lines. After repairing the CAN bus line, go to Step 2.

STEP 2. Scan tool diagnostic trouble code
Check the engine diagnostic trouble code.
Q: Is the DTC set?
YES: Perform the relevant troubleshooting.
NO: Go to Step 3.

STEP 3. Check whether the DTC is reset.
Q: Is DTC No. P0630 set?
YES: Replace the mechatronic assembly.
NO: Intermittent malfunction.