Cylinder Block Assembly: Specifications
Piston and connecting rodClearance between piston ring and ring groove mm (in)
Number 1
Standard value 0.03 - 0.07 (0.001 - 0.003)
Limit 0.1 (0.004)
Number 2
Standard value 0.03 - 0.07 (0.001 - 0.003)
Limit 0.1 (0.004)
Piston ring end gap mm (in)
Number 1
Standard value 0.15 - 0.28 (0.006 - 0.011)
Limit 0.8 (0.03)
Number 2
Standard value 0.25 - 0.40 (0.010 - 0.016)
Limit 0.8 (0.03)
Oil
Standard value 0.10 - 0.35 (0.004 - 0.014)
Limit 1.0 (0.004)
Clearance of connecting rod big end thrust mm (in)
Standard value 0.10 - 0.25 (0.004 - 0.010)
Limit 0.4 (0.016)
Connecting rod bearing oil clearance mm (in)
Standard value 0.018 - 0.045 (0.0007 - 0.0018)
Limit 0.1 (0.004)
Crankshaft and cylinder block
Crankshaft end play mm (in)
Standard value 0.05 - 0.25 (0.002 - 0.010)
Limit 0.4 (0.016)
Crankshaft journal oil clearance mm (in)
Standard value 0.012 - 0.030 (0.0005 - 0.0012)
Limit 0.1 (0.004)
Distortion of cylinder block top surface mm (in)
Standard value Within 0.05 (0.002)
Limit 0.2 (0.008)
Cylinder block cylinder bore mm (in)
Standard value 86 (3.4)
Cylindricity of cylinder block mm (in)
Standard value 0.15 (0.006)
Size codes
Upper
Lower
Main Bearing Caps
Tightening torque 26.5 ± 2.0 Nm (20 ± 1 ft-lb)
Tightening angle 45°
Crankshaft Bolt
Tighten To 210 Nm (155 ft-lb)