C1395

DTC C1395 Brake fluid filling not completed

CAUTION
^ If there is any problem in the CAN bus lines, an incorrect DTC may be set. Prior to this diagnosis, diagnose the CAN bus lines (Refer to Diagnostic trouble code diagnosis Diagnostic Trouble Code Descriptions).
^ Whenever ECU is replaced, ensure that the CAN bus lines are normal.
^ When the hydraulic unit (integrated with ASC-ECU) is replaced, always carry out the calibration of the steering wheel sensor, the G and yaw rate sensor and brake fluid pressure sensor.

DTC SET CONDITIONS
This DTC is set when the brake fluid is not filled in the hydraulic unit.

PROBABLE CAUSES
^ Different hydraulic unit (For delivery to factory)
^ ASC-ECU malfunction

DIAGNOSIS

Required Special Tools:
^ MB991958: Scan Tool (M.U.T.-III Sub Assembly)
^ MB991824: Vehicle Communication Interface (V.C.I.)
^ MB991827: M.U.T.-III USB Cable
^ MB991910: M.U.T.-III Main Harness A

STEP 1. Using scan tool MB991958, diagnose the CAN bus lines.
Use scan tool to diagnose the CAN bus lines.
Q: Is the check result normal?
YES: Go to Step 2.
NO: Repair the CAN bus lines (Refer to Diagnosis - CAN Bus Diagnostic Table CAN Bus Diagnostics Table). On completion, go to Step 2.

STEP 2. Check whether the DTC is reset.
Q: Is DTC C1395 set?
YES: Replace the hydraulic unit (ASC-ECU).
NO: The procedure is complete.