Front Door Window Motor: Service and Repair

DOOR GLASS AND REGULATOR

REMOVAL AND INSTALLATION

Pre-removal And Post-installation Operation:

Removal Steps 1-8:

Required Special Tool:
- MB990480: Window Glass Holder

Removal Steps 1-9:

Required Special Tool:
- MB990480: Window Glass Holder

Removal Steps 1-7:

REMOVAL SERVICE POINTS

[[A]] POWER WINDOW REGULATOR REMOVAL

1. Remove the door window glass installation bolts.







CAUTION: If tinting film is adhered to the door window glass, attach special tool MB990480 to the outside of the glass to prevent the film from peeling off.

2. Lift the door window glass, and attach special tool MB990480 to the glass as shown to prevent the glass from falling.
3. Remove the power window regulator.

[[B]] DOOR CENTER SASH REMOVAL







1. Remove the door outer opening weatherstrip from the door center sash only.
2. Remove the door center sash mounting screws, and then remove the door center sash from the door panel.