Scan Tool Setup

1. Connect MUT-III to the vehicle and turn the ignition switch to ON (RUN).





2. At the MUT-III main menu, choose System Select.





3. Select "From 2006 MY."

4. Click the car icon at the bottom of the screen.





5. Click the eraser icon at the bottom of the screen to erase all vehicle data.





6. Click the VIN button.





7. Click on the icon in the lower RH corner of the screen to have MUT-III automatically read the VIN. If a message appears advising the VIN cannot be input automatically enter the 17 digit VIN.

Confirm VIN is correct and click the check mark to continue.





8. If the vehicle class is not complete click the CLASS button.

NOTE:
in some cases selecting the proper transmission (arrow) automatically fills in the proper "CLASS."

9. Vehicle class can be found on the model plate attached to the right side B-pillar.








10. Make the selection for the class found on the Model Code Plate.

Click on the check mark at the bottom of the page.

11. A completed vehicle information screen appears.





12. Select the check mark. You are now finished setting up the scan tool.