Removal and Replacement

KNOCK SENSOR

REMOVAL AND INSTALLATION

CAUTION:
- When the knock sensor replacement is performed, use scan tool MB991958 to initialize the learning value (Refer to Precautions Before Service - Initialization Procedure for Learning Value in MFI Engine.)
- Do not drop or hit the knock sensor against other components. Internal damage may result, and the knock sensor will need to be replaced.

Pre-Removal And Post-Installation Operation:

Removal Steps 1-2:

INSTALLATION SERVICE POINT

]]A[[ KNOCK SENSOR INSTALLATION







Set the connector of the knock sensor to the position shown in the figure, and tighten it to the specified torque.

Tightening torque: 20 ± 2 N.m (15 ± 1 ft-lb)