Inspection Procedure 16

INSPECTION PROCEDURE 16: Noise Comes Out, But Neither AM Nor FM Sounds.

DIAGNOSTIC PROCEDURE

STEP 1. Check the state of the antenna.

Check that there is no damage or crack in the roof antenna.

Q: Is the check result normal?

YES : Go to Step 2.

NO : Repair or replace the roof antenna.

STEP 2. Check to see if inspections are taking place is an area exposed to special electric fields.

Q: Are inspections taking place under special electric field conditions (underground garage, inside a building, etc).?

YES : Go to Step 3.

NO : Go to Step 4.

STEP 3. Relocate and check.

Automatically receive in a good reception area that is not exposed to special electric fields.

Q: Is reception of the strongest radio frequency possible within the area?

YES : This diagnosis is complete.

NO : Go to Step 4.

STEP 4. Tune then check.

Q: Did the sensitivity improve after tuning?

YES : This diagnosis is complete.

NO : Go to Step 5.

STEP 5. Check the antenna plug is connected to the radio and CD player.

Q: Is the antenna plug thoroughly connected to the radio and CD player?

YES : Go to Step 6.

NO : Thoroughly the antenna plug connect to the radio and CD player.

STEP 6. Check by replacing the radio and CD player.

Q: Are operations normal when using another radio and CD player?

YES : Either repair or replace the new radio and CD player.

NO : Repair or replace the roof antenna.