P0702

DTC P0702: Internal control module, monitoring processor system (Malfunction)

CAUTION
^ If there is any problem in the CAN bus lines, an incorrect diagnostic trouble code may be set. Prior to this diagnosis, diagnose the CAN bus lines.
^ Whenever the ECU is replaced, ensure that the CAN bus lines are normal.

DIAGNOSTIC FUNCTION
TC-SST-ECU checks that the internal module and monitoring processor are normal.

DESCRIPTIONS OF MONITOR METHODS
The internal module and monitoring processor are determined to be abnormal.

PROBABLE CAUSES
^ Malfunction of TC-SST-ECU

DIAGNOSTIC PROCEDURE

Required Special Tools:
^ MB991958: Scan Tool (M.U.T.-III Sub Assembly)
^ MB991824: Vehicle Communication Interface (V.C.I.)
^ MB991827: M.U.T.-III USB Cable
^ MB991910: M.U.T.-III Main Harness A

STEP 1. Scan tool CAN bus diagnostics
Using scan tool MB991958, diagnose the CAN bus lines.
Q: Is the check result normal?
YES: Go to Step 2.
NO: Repair the CAN bus lines. After repairing the CAN bus line, go to Step 2.

STEP 2. Check the TC-SST-ECU power supply circuit
Inspection Procedure 4: TC-SST-ECU Power Supply Circuit Malfunction
Q: Is the check result normal?
YES: Go to Step 3.
NO: Repair the TC-SST-ECU power supply circuit. After repairing the power supply circuit, go to Step 3.

STEP 3. Check whether the DTC is reset.
Q: Is DTC No. P0702 set?
YES: Replace the mechatronic assembly.
NO: Intermittent malfunction.