C1624

DTC C1624: AWC-ECU System (internal Malfunction)

CAUTION
^ If there is any problem in the CAN bus lines, an incorrect diagnostic trouble code may be set. Prior to this diagnosis, diagnose the CAN bus lines.
^ Whenever the ECU is replaced, ensure that the CAN bus lines are normal.

OPERATION
AWC-ECU monitors the malfunction in the ECU.

DTC SET CONDITIONS
The code is set when a malfunction is found in AWC-ECU.

PROBABLE CAUSES
^ Malfunction of AWC-ECU

DIAGNOSTIC PROCEDURE

STEP 1. Scan tool CAN bus diagnostics
Using scan tool MB991958, diagnose the CAN bus lines.
Q: Is the check result normal?
YES: Go to Step 3.
NO: Repair the CAN bus lines. After repairing the CAN bus line, go to Step 2.

STEP 2. Check whether the DTC is reset.
Q: Is DTC No. C1624 set?
YES: Go to Step 3.
NO: This diagnosis is complete.

STEP 3. Scan tool diagnostic trouble code
Check other AWC diagnostic trouble code. (Diagnostic Trouble Code Descriptions)
Q: Is the DTC set?
YES: Perform the relevant troubleshooting.
NO: Go to Step 4.

STEP 4. Check whether the DTC is reset.
Q: Is DTC No. C1624 set?
YES: Replace the AWC-ECU. Then go to Step 5.
NO: Intermittent malfunction.

STEP 5. Check whether the DTC is reset.
Q: Is DTC No. C1624 set?
YES: Return to Step 1.
NO: This diagnosis is complete.