Cylinder Head

Cylinder Head Bolts





1) Tighten the bolts in the order shown to 78 ± 2 Nm (58 ± 1 ft-lb.)
2) Loosen the bolts fully in the reverse sequence to that shown
3) Tighten the bolts in the order shown to 20 ± 2 Nm (15 ± 1 ft-lb.)





4) Apply a paint mark to the heads of the cylinder head bolts and cylinder head.

Then tighten 90 degree angle as shown.
5) Tighten in a 90 degree angle as shown in the instructions of the figure.

Then check to see that the paint mark on the head of the cylinder head bolts and the paint mark on the cylinder head is on a linear line.