Steering Wheel Sensor Removal and Installation
STEERING WHEEL SENSORREMOVAL AND INSTALLATION
WARNING
Before removing the steering wheel and air bag module assembly, refer to Service Precautions and Air Bag Module and Clock Spring.
CAUTION
^ When centering the clock spring, always remove the clock spring from the column switch in advance. Otherwise, the sensor may be damaged.
^ If the clock spring is not correctly aligned, the steering wheel may not be turned or the cable inside the clock spring may be broken, causing the SRS to be inoperative.
^ Always carry out steering wheel sensor calibration after the steering wheel sensor has been installed. This is necessary because the TCL/ASC-ECU should update the steering neutral point.
Pre-removal & Post-installation Operation:
Removal Steps 1-2:
