Inspection Procedure 6: Noise While Turning [Differential]

INSPECTION PROCEDURE 6: Noise while Turning [DIFFERENTIAL]

DIAGNOSIS

STEP 1. Check the side bearing for wear or damage.

Q: Is the side bearing worn or damaged?
YES: Replace the part. Then go to Step 3.
NO: Go to Step 2.

STEP 2. Check the side gear, pinion gear or pinion shaft for damage.

Q: Is the side gear, pinion gear or pinion shaft damaged?
YES: Replace the part. Then go to Step 3.
NO: Go to Step 3.

STEP 3. Retest the system.

Q: Is the abnormal noise eliminated?
YES: The procedure is complete.
NO: Start over at Step 1.