Ignition Switch: Service and Repair

REMOVAL AND INSTALLATION

CAUTION:
- Before removing the steering wheel and driver's air bag module assembly, refer to Air Bag Systems, Service Precautions and Driver's Air Bag Module and Clock Spring [Except RALLIART] or [RALLIART] [Vehicles with WCM], Air Bag, Service and Repair.
- After the installation, perform a calibration for the ASC-ECU to learn the steering wheel sensor neutral point [Vehicles with WCM and ASC]

Pre-removal & Post-installation Operation:

Removal Steps 1-10:

REMOVAL SERVICE POINT

[A] STEERING LOCK CYLINDER REMOVAL [VEHICLES WITH WCM]
1. Insert the key into the steering lock cylinder, and turn the ignition key to the ACC position.







2. With using a cross-headed screw driver (small) or similar items to press in the lock pin, remove the ignition key, and then remove the steering lock cylinder.

INSTALLATION SERVICE POINT

[A] WIRELESS CONTROL MODULE [VEHICLES WITH WCM]/RECEIVER ANTENNA MODULE [VEHICLES WITH KOS] INSTALLATION
Check that the top claw of receiver antenna module is fixed securely to the boss of steering lock and the antenna is not floated on the key cylinder.