Inspection Procedure 2

Inspection Procedure 2: The speedometer does not work (the other meters work).

TECHNICAL DESCRIPTION (COMMENT)
If only the speedometer does not operate, the ABS-ECU [Vehicles without ASC] or ASC-ECU [Vehicles with ASC] or engine control module [Vehicles without ABS] and combination meter may have a problem.

TROUBLESHOOTING HINTS
- The ABS-ECU may be defective [Vehicles without ASC]
- The ASC-ECU may be defective [Vehicles with ASC]
- The engine control module may be defective [Vehicles without ABS]
- The combination meter may be defective

DIAGNOSIS

Required Special Tools:
- MB991958: Scan Tool (M.U.T.-III Sub Assembly)
- MB991824: Vehicles Communication Interface (V.C.I.)
- MB991827: M.U.T.-III USB Cable
- MB991910: M.U.T.-III Main Harness A (Vehicles with CAN communication system)

STEP 1. Using scan tool MB991958, diagnose the CAN bus line.







CAUTION: To prevent damage to scan tool MB991958, always turn the ignition switch to the "LOCK" (OFF) position before connecting or disconnecting scan tool MB991958.

1. Connect scan tool MB991958. Refer to "How to connect the Scan Tool (M.U.T.-III)." How to Connect the Scan Tool (M.U.T.-III)
2. Turn the ignition switch to the "ON" position.
3. Diagnose the CAN bus line.
4. Turn the ignition switch to the "LOCK" (OFF) position.

Q: Is the CAN bus line found to be normal?

YES : Go to Step 2.

NO : Repair the CAN bus line.

STEP 2. Using scan tool MB991958, read the combination meter diagnostic trouble code.

Check if DTC is set to the combination meter.

Q: Is the DTC set?

YES : Troubleshoot the combination meter. Diagnostic Trouble Code Descriptions

NO : Go to Step 3.

STEP 3. Using scan tool MB991958, read the ABS-ECU [Vehicles without ASC] or ASC-ECU [Vehicles with ASC] or engine control module [Vehicles without ABS] diagnostic trouble code.

Check if diagnosis code is set to the ABS-ECU or ASC-ECU or engine control module.

Q: Is the DTC set?

YES : Troubleshoot the ABS or ASC or MFI (Refer to Diagnosis Diagnostic Trouble Code Descriptions or Diagnosis Diagnostic Trouble Code Descriptions or Diagnosis Code Chart [2.0 L engine non-turbo]). Diagnostic Trouble Code Descriptions

NO : Go to Step 4.

STEP 4. Using scan tool MB991958, check data list.

1. Turn the ignition switch to the "ON" position.
2. Check the data list on the combination meter.
- Item 80: Speedometer
- Should read vehicle speed.

3. Turn the ignition switch to the "LOCK" (OFF) position.

Q: Does it read vehicle speed?

YES : Go to Step 5.

NO : Replace the combination meter.

STEP 5. Using scan tool MB991958, check actuator test.

1. Turn the ignition switch to the "ON" position.
2. Conduct the actuator test of the combination meter.
- Item 1: Speedometer
- The speedometer operates up to the set position.

3. Turn the ignition switch to the "LOCK" (OFF) position.

Q: Is the check result normally?

YES : Go to Step 6.

NO : Replace the combination meter.

STEP 6. Retest the system.

Check that the speedometer works normally.

Q: Is the check result normal?

YES : The procedure is complete.

NO : Go to Step 1.