Inspection Procedure 3: ABS Warning Light Does Not Illuminate When Ignition Switch Is Turned to the on Position Engine Stopped

Inspection Procedure 3: ABS Warning Light does not Illuminate when Ignition Switch is Turned to the ON Position (Engine Stopped).

CAUTION
^ If there is any problem in the CAN bus lines, an incorrect DTC may be set. Prior to this diagnosis, diagnose the CAN bus lines.
^ Whenever ECU is replaced, ensure that the CAN bus lines are normal.

SYSTEM OPERATION
^ ABS-ECU sends the illumination request signal of the ABS warning light to the combination meter through ETACS-ECU via CAN communication.
^ ABS-ECU illuminates the ABS warning light via ETACS-ECU for approximately 3 seconds for valve check with the ignition switch turned to the ON position.

COMMENTS ON TROUBLE SYMPTOM
This may be caused by faults in the CAN bus line, ETACS-ECU, combination meter or ABS-ECU.

PROBABLE CAUSES
^ Damaged wiring harness and connectors
^ Malfunction of ETACS-ECU
^ Combination meter malfunction
^ ABS-ECU malfunction
^ Malfunction of coding data for ETACS-ECU

DIAGNOSIS

Required Special Tools:
^ MB991958: Scan Tool (M.U.T.-III Sub Assembly)
^ MB991824: Vehicle Communication Interface (V.C.I.)
^ MB991827: M.U.T.-III USB Cable
^ MB991910: M.U.T.-III Main Harness A

STEP 1. M.U.T.-III CAN bus diagnostics
Use scan tool to diagnose the CAN bus lines.

Q: Is the check result normal?
YES: Go to Step 2.
NO: Repair the CAN bus lines. Then go to Step 8.

STEP 2. M.U.T.-III DTC
Use scan tool to check the DTC for the ABS system.

Q: Is the DTC set?
YES: Carry out the diagnosis for the DTC.
NO: Go to Step 3.

STEP 3. M.U.T.-III actuator test
Perform the following actuator test by the combination meter system, and check if the ABS warning light illuminates.
^ Item No.07: Indicator 1

Q: Is the check result normal?
YES: Go to Step 4.
NO: Replace the combination meter. Then go to Step 8.

STEP 4. Check coding data
Use scan tool to check if coding data stored in ETACS-ECU is normal.

Q: Is the check result normal?
YES: Go to Step 5.
NO: Replace the ETACS-ECU. Then go to Step 8.

STEP 5. M.U.T.-III other system DTC
Using scan tool, check that the DTC U0141 is not set by the combination meter system.

Q: Is the DTC set?
YES: Diagnose the combination meter. Then go to Step 8.
NO: Go to Step 6.

STEP 6. M.U.T.-III DTC for other systems
Using scan tool, check that the DTC U0121 is not set by the ETACS system.

Q: Is the DTC set?
YES: Perform troubleshooting on ETACS-ECU. Then go to Step 8.
NO: Go to Step 7.

STEP 7. Retest the system.

Q: Does the ABS warning light turn ON and OFF normally?
YES: Intermittent malfunction.
NO: Replace the ABS-ECU. Then go to Step 8.

STEP 8. Retest the system.

Q: Does the ABS warning light turn ON and OFF normally?
YES: The procedure is complete.
NO: Return to Step 1.