MMCS

DTC U0164: A/C CAN timeout

CAUTION:
- If DTC U0164 is set, be sure to diagnose the CAN bus line.
- When replacing the CAN box unit, always check that the communication circuit is normal. (Check that the voltage is 10 V or more.)

DIAGNOSTIC FUNCTION
If the signal from A/C-ECU [vehicle with A/C] or heater control unit [vehicle without A/C] cannot be received, the CAN box unit sets DTC U0164.

JUDGMENT CRITERIA
With the ignition switch in the ON position, system voltage between 10-16 volts (data from ETACS-ECU), power supply fuse (IOD fuse) is OK, or odometer value is 80.5 km (50 miles) or more, and the communication with A/C-ECU [vehicle with A/C] or heater control unit [vehicle without A/C] cannot be established for 2,500 ms or more, the CAN box unit determines that a problem has occurred.

TROUBLESHOOTING HINTS
- The CAN bus line may be defective.
- The A/C-ECU [vehicle with A/C] or heater control unit [vehicle without A/C] may be defective.
- The CAN box unit may be defective.

DIAGNOSIS

Required Special Tools:
- MB991958 Scan Tool (M.U.T.-III Sub Assembly)
- MB991824: Vehicles Communication Interface (V.C.I.)
- MB991827 M.U.T.-III USB Cable
- MB991910 M.U.T.-III Main Harness A (Vehicles with CAN communication system)

STEP 1. Using scan tool MB991958, diagnose the CAN bus line.







CAUTION: To prevent damage to scan tool MB991958, always turn the ignition switch to the "LOCK" (OFF) position before connecting or disconnecting scan tool MB991958.

1. Connect scan tool MB991958. Refer to "How to connect the Scan Tool (M.U.T.-III)." How to Connect the Scan Tool (M.U.T.-III)
2. Turn the ignition switch to the "ON" position.
3. Diagnose the CAN bus line.
4. Turn the ignition switch to the "LOCK" (OFF) position.

Q: Is the CAN bus line found to be normal?

YES : Go to Step 2.

NO : Repair the CAN bus line.

STEP 2. Using scan tool MB991958, read the A/C-ECU [vehicle with A/C] or heater control unit [vehicle without A/C] diagnostic trouble code.

Check if DTC is set to the A/C-ECU [vehicle with A/C] or heater control unit [vehicle without A/C].

Q: Is the DTC set?

YES : Troubleshoot the A/C-ECU [vehicle with A/C] or heater control unit [vehicle without A/C] (Refer to Manual A/C Diagnosis [vehicles with manual A/C] Diagnostic Trouble Code Descriptions or Automatic A/C Diagnosis [vehicles with automatic A/C]). Diagnostic Trouble Code Descriptions

NO : Go to Step 3.

STEP 3. Recheck for diagnostic trouble code.

Check again if the DTC is set to the CAN box unit.

1. Erase the DTC.
2. Turn the ignition switch from "LOCK" (OFF) position to "ON" position.
3. Check if DTC is set.
4. Turn the ignition switch to the "LOCK" (OFF) position.

Q: Is the DTC set?

YES : Replace the CAN box unit.

NO : The trouble can be an intermittent malfunction.