Suspension - Revised Rear Control Arm Mounting Nuts
No: TSB-08-34-003DATE: June, 2008
MODEL:
2008-09 Lancer
SUBJECT:
CHANGE FROM WELD NUTS TO FLANGE NUTS FOR REAR SUSPENSION - SERVICE MANUAL REVISION
PURPOSE
To improve ease of installation on the production line, the mounting nuts to install the upper arms to the rear suspension crossmember have been changed from weld nuts to flange nuts. This Technical Service Bulletin provides the corrected illustrations and information relating to the change.
AFFECTED VEHICLE(S)
^ 2008 - 09 Lancer built from the beginning of August 2007.
^ Vehicles built with weld nuts where the rear suspension crossmember is being replaced.
APPLICABLE MANUAL(S)
Attachment 1 - Page 34-8
Attachment 2 - Page 34-22
Attachment 3 - Page 34-8
Attachment 4 - Page 34-23