Air/Fuel Mixture: Testing and Inspection
IDLE MIXTURE CHECKRequired Special Tool:
MB991958: Scan Tool (M.U.T-III Sub Assembly)
^ MB991824: V.C.I.
^ MB991827: M.U.T.-III USB Cable
^ MB991910: M.U.T.-III Main Harness A
1. Before inspection, set the vehicle in the following condition:
^ Engine coolant temperature: 80 - 95° C (176 - 203° F)
^ Lights and all accessories: OFF
^ Transaxle: Neutral (P range on vehicles with CVT)
NOTE:On vehicles for Canada, the headlight, taillight, etc. remain lit even when the lighting switch is in "OFF" position but this is no problem for checks.
CAUTION
To prevent damage to scan tool MB9911958, always turn the ignition switch to the "LOCK" (OFF) position before connecting or disconnecting scan tool MB99119583
2. Connect scan tool MB991958 to the data link connector.
3. Set the timing light to the power supply line (terminal No. 3) of the ignition coil No. 1.
4. Start the engine and let it run at idle.
5. Check that the actual ignition timing is at the standard value.
Standard value: Approximately 10° BTDC
NOTE: Ignition timing fluctuates about ± 7° Before Top Dead Center, even under normal operating condition.
NOTE: It is automatically further advanced by about 5° to 10° Before Top Dead Center at higher altitudes.
6. Run the engine and increase the engine speed to 2,500 r/min for 2 minutes.
7. Set the CO, HC tester.
8. Check the CO contents and the HC contents at idle.
Standard value:
CO contents: 0.5% or less
HC contents: 100 ppm or less
9. If there is a deviation from the standard value, inspect the MFI system.
10. Remove the timing light.
CAUTION
To prevent damage to scan tool MB9911958, always turn the ignition switch to the "LOCK" (OFF) position before connecting or disconnecting scan tool MB9911958.
11. Disconnect scan tool MB991958 from the data link connector.