Keyless Operation System (KOS)
DTC B2352: Antenna failCAUTION: When replacing the ECU, always check that the communication circuit is normal.
Receiver Antenna Module And KOS-ECU Circuit:
DTC SET CONDITION
If an open circuit or short to ground occurs in the antenna, KOS-ECU sets DTC B2352.
TECHNICAL DESCRIPTION (COMMENT)
When the ignition switch is turned ON, KOS-ECU sends signals to the receiver antenna module. The receiver antenna transmits random numbers to the emergency key when it receives signals from KOS-ECU. If an open circuit or short to ground occurs on the wiring harness between KOS-ECU and receiver antenna at this time, KOS-ECU deter- mines that there is a problem.
TROUBLESHOOTING HINTS
- Malfunction of the receiver antenna module
- Damaged wiring harness and connectors
- Malfunction of KOS-ECU
DIAGNOSIS
Required Special Tools:
- MB991958: Scan Tool (M.U.T.-III Sub Assembly)
- MB991824: Vehicles Communication Interface (V.C.I.)
- MB991827: M.U.T.-III USB Cable
- MB991910: M.U.T.-III Main Harness A
STEP 1. Using scan tool MB991958, read the diagnostic trouble code.
Check if DTC B2415 is set to the KOS-ECU.
CAUTION: To prevent damage to scan tool MB991958, always turn the ignition switch to the "LOCK" (OFF) position before connecting or disconnecting scan tool MB991958.
1. Connect scan tool MB991958. Refer to "How to connect scan too (M.U.T.-III)." How To Connect The Scan Tool (M.U.T.-III)
2. Turn the ignition switch to the "ON" position.
3. Check if DTC is set.
4. Turn the ignition switch to the "LOCK" (OFF) position.
Q:Is DTC B2415 set?
YES : B2415 B2415
NO : Go to Step 2.
STEP 2. Check receiver antenna module connector C-10 and KOS-ECU connector C-31 for loose, corroded or damaged terminals, or terminals pushed back in the connector.
Q:Is the receiver antenna module connector C-10 and KOS-ECU connector C-31 in good condition?
YES : Go to Step 3.
NO : Repair the defective connector.
STEP 3. Check the wiring harness between the receiver antenna module connector C-10 (terminal No. 1, 2) and the KOS-ECU connector C-31 (terminal No. 12, 11).
- Check the signal lines for open circuit and short circuit.
Q:Is the wiring harness between receiver antenna module connector C-10 (terminal No. 1, 2) and the KOS-ECU connector C-31 (terminal No. 12, 11) in good condition?
YES : Go to Step 4.
NO : The wiring harness may be damaged or the connector(s) may have loose, corroded or damaged terminals, or terminals pushed back in the connector. Repair the wiring harness as necessary.
STEP 4. Replace the receiver antenna module, and check whether the diagnostic trouble code is reset.
1. Erase the DTC.
2. Turn the ignition switch from the "LOCK" (OFF) position to the "ON" position.
3. Check if the DTC is set.
Q:Is the DTC set?
YES : Replace KOS-ECU and register the ID codes.
NO : The procedure is complete.