For Differential

Updated by TSB-09-27-004

REAR AXLE OIL (FOR DIFFERENTIAL PART) (CHANGE)





1. Remove the filler plug.
2. Remove the drain plug and drain oil.
3. Install the drain plug, and tighten it to the specified torque.

Tightening torque: 32 ± 2 Nm (23 ± 2 ft-lb)

4. Fill the specified gear oil up to the bottom of the filler plug hole. After the gear oil reaches the bottom of the filler plug hole, leave it for 1 minute. Then add the gear oil up to the bottom of the hole or until the oil overflows. If the oil overflows, wipe it off thoroughly.

CAUTION: Take time to add the LSD gear oil because it has high viscosity and poor fluidity. If the ambient temperature is under 15° C (59° F), fill the oil at a slower rate.

Specified gear oil: MITSUBISHI Genuine DIA QUEEN Multi gear oil LS
Amount to use: 0.55 ± 0.02 dm3 (0.58 ± 0.02 qt)

5. Install the filler plug, and tighten it to the specified torque.

Tightening torque: 49 ± 10 Nm (37 ± 7 ft-lb)