Compass Calibration One Turn Magnetic Compensation

COMPASS CALIBRATION (MIDDLE GRADE TYPE)

MANUAL CALIBRATION (BY TURNING THE VEHICLE)
The multi-center display can show the direction of the vehicle by means of its compass sensor. The compass sensor is calibrated automatically when the vehicle is driven and turned, and do not normally require calibration. But, if the sensor is magnetized strongly by any reason, the compass may show inaccurate direction. In this case, a manual calibration of the compass sensor will be necessary.

NOTE: The compass returns to the correct compass direction vehicle moves to an area where the geomagnetism is stabilized.

1. Ignition switch "ACC" position.




2. A set-up screen will be called up by pressing to hold the "DISP" button switch on the multi-center display.




3. Choose "Next Menu (Operable only with vehicle stationary)" by pressing function button switch 2, and then press function button switch 3 (ENTER).




4. The compass setting screen is called up. Choose "compass calibration" by pressing function button switch 2, and then press function button switch 3 (ENTER).




5. Choose function button switch 2 ("YES") on the compass calibration screen.




6. After the message is shown, drive the vehicle in one circle.
7. If the calibration is made successfully, the display unit buzzer will sound twice.

NOTE: If the calibration fails, a message will appear to indicate it.