Reset Procedure
TPMS SPECIAL FUNCTIONTIRE PRESSURE SENSOR ID REGISTRATION
When the TPMS transmitter and TPMS receiver are replaced, execute "Tire Pressure Sensor ID Registration." The TPMS won't function until the "Tire Pressure Sensor ID Registration" has been complete.
Required Special Tools:
- MIT46716: TPMS Magnet
- MB991958: Scan Tool (M.U.T.-III Sub Assembly)
- MB991824: Vehicle Communication Interface (V.C.I.)
- MB991827: M.U.T.-III USB Cable
- MB991910: M.U.T.-III Main Harness
Register the tire pressure sensor IDs as described in the procedure below.
CAUTION: To prevent damage to scan tool MB991958, always turn the ignition switch to the "LOCK" (OFF) position before connecting or disconnecting scan tool MB991958.
1. Connect scan tool MB991958 to the data link connector.
2. Turn the ignition switch to the "ON" position.
3. Select "Interactive Diagnosis" from the start-up screen.
4. Select "System select."
5. Choose "TPMS" from the "CHASSIS" tab.
6. Select "MITSUBISHI."
7. Select "Special Function."
8. Select "Tire Pressure Sensor ID Registration."
CAUTION: Register all tire pressure sensor IDs within five minutes.
9. Select "4tires PRES SNSR ID Registration (COMPACT SPARE TIRE)" and start the tire pressure sensor ID registration.
10. Emit signal from a TPMS transmitter as follows:
NOTE: You can start out the following operations from any TPMS transmitter. The tire pressure sensor ID registration has no order.
(1) Clean the TPMS transmitter location on the wheel rim.
(2) Position MIT46716 or a strong magnet as shown, and hold it there for 5 seconds or more.
NOTE: By doing this work, the reed switch (incorporated in the TPMS transmitter) will activate the TPMS transmitter to send the tire pressure sensor ID.
NOTE: If the TPMS transmitter is not activated, slide the magnet until it is activated. If the TPMS transmitter is still not activated, move the vehicle (turn the tire) by approximately half a turn of the tire. Then attempt to activate the TPMS transmitter.
11. Check completion of the above through scan tool MB991958.
12. Repeat the above steps 8 and 9 for all TPMS transmitter-fitted tires.
13. Check the completion of the tire pressure sensor ID registration (display on the screen).
14. After tire pressure sensor ID registration, turn the ignition switch to the "LOCK" (OFF) position.
15. Remove scan tool MB991958.