Inspection Procedure 24

INSPECTION PROCEDURE 24: CD player, CD auto changer: CD can not be Inserted.

DIAGNOSIS

STEP 1. Check that a CD has been already loaded.

Q: Has a CD been already loaded?

YES : Take out the CD (If the CD can not be ejected, refer to INSPECTION PROCEDURE 27 Inspection Procedure 27). Check that a CD can be inserted.

NO : Go to Step 2.

STEP 2. Check how a CD is inserted.

Ensure that the ignition switch is at 'ACC' or 'ON'.

NOTE: If you try to load a CD when the ignition switch is at the positions other than 'ACC' or 'ON,' the CD will not be inserted completely and then rejected.

Q: If you try to load the CD, does the CD stops halfway and then rejected?

YES : Refer to INSPECTION PROCEDURE 27. Inspection Procedure 27

NO : Go to Step 3.

STEP 3. Check after the CD is loaded.

NOTE: Even though the CD is loaded, 'E01' [vehicles with multi-center display (low grade type)] or 'ERROR 01' [vehicles with multi-center display (middle grade type)] sometimes displayed with the CD rejected because of vibration/shock or dew on the CD face or optical lens.

Q: Though the CD is inserted completely, is 'E01' [vehicles with multi-center display (low grade type)] or 'ERROR 01' [vehicles with multi-center display (middle grade type)] displayed and the CD ejected?

YES : Go to Step 4.

NO : There is no action to be taken.

STEP 4. Check the CD.

Check the CD for the conditions below:
- Is the CD loaded with its label facing down?
- Is the recorded face dirty or scratched?
- Is there dew on the recorded face?

Q: Is the CD in good condition?

YES : Go to Step 5.

NO : The original CD is defective. Check that a known good CD can be inserted.

STEP 5. Check again using a normal CD, which is not dirty or scratched.
- Load another normal CD.
- Check that the CD player recognizes and plays the CD.

Q: When you substitute another normal CD, is the CD loaded correctly

YES : The original CD is defective. Check that a CD can be inserted.

NO : Replace the CD player. Check that a CD can be inserted.