Initial Inspection and Diagnostic Overview
TROUBLESHOOTING GUIDEThe starting system troubleshooting guide is shown in the following steps.
WARNING: Battery posts, terminals and related accessories contain lead and lead compounds. WASH HANDS AFTER HANDLING.
STEP 1.
Q: Is the battery in good condition? (Refer to Chassis Electrical -Battery -On-vehicle Service Battery Check.)
YES: Go to Step 2.
NO: Charge or replace the battery.
STEP 2.
- Disconnect the starter motor S (solenoid) terminal connector.
- Using a jumper wire, apply battery positive voltage to the starter motor S (solenoid) terminal.
- Check the engine condition.
OK: Turns normally
Q: Does the starter motor operate normally?
YES:
- Check the ignition switch (Refer to Chassis Electrical -Ignition Switch -Ignition Switch -Inspection.)
- Check the starter relay and interlock switch.
- Check the transmission range switch. (Refer to Automatic Transaxle - On-vehicle Service - Essential Service - Transmission Range Switch Check.)
- Check the line between the battery and starter motor S (solenoid) terminal.
NO: Go to Step 3.
STEP 3.
- Check the cable between starter B (battery) terminal and battery positive terminal for connection and continuity.
Q: Is the starter cable in good condition?
YES: Go to Step 4.
NO: Repair or replace the cable.
STEP 4.
- Check the connection and the continuity of the cable between the starter motor body and the negative battery terminal.
Q: Is the ground line in good condition?
YES: Go to Step 5.
NO: Repair or replace the cable.
STEP 5.
Q: Is the starter motor in good condition? (Refer to Starting System -Starter Motor Assembly -Inspection)
YES: Excessive rotational resistance of the engine.
NO: Replace the starter motor.