Rear Wiper and Washer

REAR WIPER AND WASHER

REMOVAL AND INSTALLATION

Removal Steps 1-8:

NOTE: For removal and installation of the wiper and washer switch, refer to Chassis Electrical, Column switch.

REMOVAL SERVICE POINT

[[A]] REAR WIPER MOTOR ASSEMBLY REMOVAL






Close the trunk lid slightly and lower the trunk lid torsion bar slightly when removing the rear wiper motor assembly. If you fail to do this the rear wiper motor assembly will interfere with the trunk lid torsion bar.

INSTALLATION SERVICE POINTS

]]A[[ REAR WIPER MOTOR ASSEMBLY INSTALLATION






Close the trunk lid slightly and lower the trunk lid torsion bar slightly when installing the rear wiper motor assembly. If you fail to do this the rear wiper motor assembly will interfere with the trunk lid torsion bar.

]]B[[ WIPER BLADE INSTALLATION






CAUTION: Use a curved backing like that shown for the backing of a wiper blade to ensure sustained wiper wiping performance.

]]C[[ WIPER BLADE ASSEMBLY INSTALLATION






Before installing the rear wiper arm and blade assembly operate the rear wiper motor so that the motor stops at the predetermined park position. Install the rear wipe arm and blade assembly and adjust the rear wiper blade position so that the blade end stops at the predetermined position (standard position).

Standard value: (A) 38 ± 5 mm (1.5 ± 0.20 inch)