Adjustment

FOG LIGHT ADJUSTMENT




1. Check if the beam shining onto the screen is at the standard value




2. If it is not within the standard value range, adjust by turning the adjusting screw

Standard value: (Vertical direction): Top of the hot zone should be 101 mm (40 inches) (076 degrees angle) downward from the height of the fog light center

Limit: (Vertical direction): Top of the hot zone should be 152mm (60 inches) (114 degrees angle) in maximum downward from the height of the fog light center

NOTE: The horizontal direction is non-adjustable If deviation of the light beam axis exceeds the standard value, check that the mounting location or some other points are not faulty