Inspection Procedure 6

INSPECTION PROCEDURE 6: When "CRUISE" (MAIN) Switch is Turned "ON", "CRUISE" Indicator Light Inside Combination Meter does not Illuminate. (However, Auto-cruise Control System is Normal).

Auto-cruise Control Indicator Light Drive Circuit Part 1:

Auto-cruise Control Indicator Light Drive Circuit Part 2:

CIRCUIT OPERATION
The PCM detects "CRUISE" (MAIN) switch "ON" signal to illuminate the "CRUISE" indicator light on the combination meter.

COMMENT
Connector(s), wiring harness in the CAN bus line between the PCM and the combination meter, power supply to the PCM, the combination meter, the PCM may be defective.

TROUBLESHOOTING HINTS
- Malfunction of the combination meter.
- Damaged harness or connector.
- Malfunction of the PCM.

DIAGNOSIS

Required Special Tools:
- MB991958: Scan Tool (M.U.T.-III Sub Assembly)
- MB991824: V.C.I.
- MB991827: M.U.T.-III USB Cable
- MB991910: M.U.T.-III Main Harness A

STEP 1. Using scan tool MB991958, diagnose the CAN bus line.

CAUTION: To prevent damage to scan tool MB991958, always turn the ignition switch to the "LOCK" (OFF) position before connecting or disconnecting scan tool MB991958.




1. Connect scan tool MB991958 to the data link connector.
2. Turn the ignition switch to the "ON" position.
3. Diagnose the CAN bus line.
4. Turn the ignition switch to the "LOCK" (OFF) position.
5. Disconnect scan tool MB991958.

Q: Is the check result satisfactory?

YES: Go to Step 2

NO: Repair the CAN bus lines. (Refer to Diagnosis - Can Bus Diagnostic Chart in Information Bus). Then go to Step 4.

STEP 2. Using scan tool MB991958, read the MFI diagnostic trouble code.

CAUTION: To prevent damage to scan tool MB991958, always turn the ignition switch to the "LOCK" (OFF) position before connecting or disconnecting scan tool MB991958.




1. Connect scan tool MB991958 to the data link connector.
2. Turn the ignition switch to the "ON" position.
3. Check for MFI system diagnostic trouble code (Refer to MFI Diagnosis - Diagnostic Function - How to Read and Erase Diagnostic Trouble Code) <2.4L engine> or (Refer to MFI Diagnosis - Diagnostic Function - How to Read and Erase Diagnostic Trouble Code) <3.8L engine>. Reading Diagnostic Trouble Codes
4. Turn the ignition switch to the "LOCK" (OFF) position.
5. Disconnect scan tool MB991958.

Q: Is DTC U1108 set?

YES: Refer to MFI Diagnosis - Diagnostic Trouble Code Procedures - DTC U1108: Combination Meter-ECU CAN Communication Time Out <2.4L engine> or Refer to MFI Diagnosis - Diagnostic Trouble Code Procedures - DTC U1108: Combination Meter-ECU CAN Communication Time Out <3.8L engine>. Then go to Step 4.

NO: Go to Step 3.

STEP 3. Retest the system.

Q: Does the "CRUISE" indicator light illuminate when the "CRUISE" (MAIN) switch is turned "ON"?

YES: It can be assumed that this malfunction is intermittent.

NO: Replace the PCM. When the PCM is replaced, register the encrypted code. Refer to Ignition Switch - Encrypted Code Registration Criteria Table in Antitheft and Alarm Systems. Then go to Step 4.

STEP 4. Retest the system.

Q: Does the "CRUISE" indicator light illuminate when the "CRUISE" (MAIN) switch is turned "ON"?

YES: The procedure is complete.

NO: Return to Step 1.