Evaporative Emissions System: Service and Repair

FUEL TANK

REMOVAL AND INSTALLATION

Part 1:

Part 2:

Required Special Tool:
- MB991348: Test Harness Set

REMOVAL SERVICE POINTS

<> DISCONNECT HARNESS CONNECTOR/FUEL WIRING HARNESS/FUEL TANK ASSEMBLY REMOVAL

Lower the fuel tank assembly halfway to disconnect the fuel tank harness connector and fuel wiring harness.

INSTALLATION SERVICE POINT

>>A<< FUEL HIGH-PRESSURE HOSE INSTALLATION






CAUTION: After connecting the quick action joint of the fuel high-pressure hose, pull the joint lightly away from the quick action joint to confirm that it is secure. In addition, confirm that there is a play of approximately 3.0 mm (0.12 inch) at the joint.