Inspection Procedure 3

The Compass is not Correct.

STEP 1. Check the vehicle location

Q: Are there any constructions, such as high-voltage wires or a steel bridge, which might affect the compass sensor?

YES: After moving to a location where the magnetic field is stable, check the faulty condition again.

NO: Go to Step 2.

STEP 2. Correct magnetization

Q: Was magnetization corrected?

YES: Go to Step 3.

NO: Correct magnetization. (Refer to Vehicle Magnetic Compensation.)

STEP 3.Correct magnetic declination

Q: Was magnetic declination corrected?

YES: Go to Step 4.

NO: Correct the magnetic declination. (Refer to Compass Calibration.)

STEP 4. Demagnetize

Q: Was that demagnetized?

YES: Replace the compass sensor.

NO: Demagnetize it. (Refer to Vehicle Magnetic Compensation.)