Without Scan Tool
Erasing Diagnostic Trouble CodesThe diagnostic trouble codes can be erased by the following procedure.
NOTE: The diagnostic trouble code will not be erased even if the negative battery terminal is disconnected.
Without using scan tool MB991502
1. Turn the ignition switch to the "ON" position while holding the auto-cruise control switch in the "SET" (down) position. Then, within one second, more the auto-cruise control switch up to the "RES" position.
2. Check to make sure the "CRUISE" light on the instrument panel is flashing.
3. Put the auto-cruise control switch in the "SET" (down) position.
Depress the brake pedal and hold for five seconds or more. Release the brake pedal, auto-cruise control switch, then turn the ignition switch to the "LOCK" (OFF) position. The DTC(s) are now erased.