Intake Air Plenum
FASTENER TIGHTENING SPECIFICATIONSINTAKE MANIFOLD PLENUM <3.0L Engine>
ITEM SPECIFICATION
Control wiring harness connector bracket bolt 5.0 ± 1.0 N.m (44 ± 9 in-lb)
EGR pipe connection bolt 18 ± 2 N.m (13 ± 2 ft-lb)
EGR valve bolt 21 ± 4 N.m (16 ± 2 ft-lb)
Engine mount stay bolt 36 ± 6 N.m (27 ± 4 ft-lb)
Evaporative emission purge solenoid valve bolt [Vehicle with variable induction control (VIC) system] 9.0 ± 1.0 N.m (80 ± 9 in-lb)
Ground wire attaching bolt [Vehicle with variable induction control (VIC) System] 5.0 ± 1.0 N.m (44 ± 9 in-lb)
Heater pipe bolt 18 ± 2 N.m (13 ± 2 ft-lb)
Intake manifold plenum bolt and nut 18 ± 2 N.m (13 ± 2 ft-lb)
Intake manifold plenum stay bolt, front and rear
M8 18 ± 2 N.m (13 ± 2 ft-lb)
M1O 36 ± 6 N.m (27 ± 4 ft-lb)
Manifold differential pressure sensor bolt 5.0 ± 1.0 N.m (44 ± 9 in-lb)
Power steering oil pump bracket stay bolt (bolt, washer assembly) 44 ± 10 N.m (33 ± 7 ft-lb)
Power steering oil pump bracket stay bolt (bolt, flange) 24 ± 4 N.m (18 ± 3 ft-lb)
Power steering oil pump nut 42 ± 7 N.m (31 ± 5 ft-lb)
Sensor connector assembly bolt 11 ± 1 N.m (98 ± 8 in-lb)
Vacuum control valve [Vehicle with variable induction control (VIC) system] 11 ± 1 N.m (98 ± 8 in-lb)
Vacuum pipe assembly bolt 11 ± 1 N.m (98 ± 8 in-lb)
Vacuum tank bolt [Vehicle with variable induction control (VIC) system]
M6 9.0 ± 1.0 N.m (80 ± 9 in-lb)
M8 18 ± 2 N.m (13 ± 2 in-lb)
Valve assembly bolt 9.0 ± 1.0 N.m (80 ± 9 in-lb)