Headlight Adjustment

HEADLIGHT ADJUSTMENT

1. The low beam headlight should project on the screen upper edge of the beam (cut-off)




2. If not the case, turn the adjusting screws to achieve the specified low-beam cut-off location on the aiming screen.

Standard value: (vertical direction) Headlight center line 53 mm (+2.1 inches)




3. When adjusting one headlight,disconnect the other headlight harness.

CAUTION: Do not cover a headlight for more than three minutes to prevent the plastic headlight lens deformation.

4. There is no horizontal aim adjustment. Horizontal aim is preset and dose not require adjustment. High-beam pattern should be correct when the low-beams are adjusted properly.