Radiator Cooling Fan Control Module: Testing and Inspection

FAN CONTROLLER CHECK





1. Remove the fan controller connector.
2. Turn the ignition switch to the ON position, and measure the voltage between the harness-side connector terminals.
Standard value: Battery positive voltage





3. Connect the fan controller connector, and disconnect the condenser fan motor connector.
4. Ensure that the A/C switch is off, and start the engine and run it at idle.
5. Measure the voltage between the fan controller-side connector terminals.
Standard value: 1V or less
6. Turn the A/C switch to the ON position.

WARNING: Be careful to stay clear of the fan since the fan starts running.

7. Measure the voltage between the fan controller-side connector terminals while the fan is running. The voltage should repeat the values 1 and 2.
Standard value:
1) 8.2 ± 2.6 V
2) Battery positive voltage ±2.6 V
8. If the voltage does not repeatedly change as indicated, replace the fan controller.








FAN CONTROL RELAY CONTINUITY CHECK