Codealarm RKE Only

CODEALARM RKE ONLY (Port/Dealer installed - Not included in service manual)
2002 Mirage

NOTE:
For technical assistance on installing and servicing CodeAlarm systems, call 800-421-3209 Monday-Friday between 8:00 a.m. and 7:00 p.m. or Saturday between 10:00 a.m. and 2:00 p.m. Eastern Time.

System Operation:
Push the LOCK button to lock all doors. Push the UNLOCK button to unlock all doors and illuminate the dome light for 60 seconds or until the ignition key is turned to the ON position.

After the ignition key is turned to the OFF position, the dome lamp will remain illuminated for 60 seconds.

Receiver Module Location: Behind knee bolster on driver's side.

Ignition Switch Connection: 6-pin ignition switch connector on left side of steering column
Ground Connection: Hex bolt on left side kick panel

Courtesy Light Connection: At ETACS unit connected to fuse block.

Door Lock Connection: Near the ETACS unit with fuse block.

CODEALARM (RKE Only) Transmitter Programming:

1. Locate the programming button in the RKE harness near the RKE receiver.

2. Open driver's door. Leave door open until programming is completed.

3. Turn the ignition key to the ON position. Press and hold the programming button for about 15 seconds. The power door locks should lock and unlock three times.

4. While still holding the programming button down, press the LOCK button on the first transmitter. The door locks should lock and unlock.

5. While still holding the programming button down, press the LOCK button on the second transmitter. The door locks should lock and unlock.

6. Release the programming button.

7. Turn the ignition key to the OFF position.

8. Verify that both transmitters operate properly.