Transmitter Battery Replacement

OMRON TRANSMITTER BATTERY REPLACEMENT





1. Remove the set screw, open the transmitter case and remove the battery.

2. Insert the new battery with the "+" side DOWN.
Replacement battery: Lithium, coin type CR2032

3. Inserting the claw first, reassemble the transmitter case.

CAUTION
Be careful not to deform the battery electrodes when replacing, ensure that water and dirt do not enter, and that you do not directly touch the printed circuit board.

4. Verify that the keyless entry system operates properly. It is not necessary to reprogram the remote transmitter after changing the battery.

CODE ALARM TRANSMITTER BATTERY REPLACEMENT





1. If there is a small screw on the back of the transmitter, remove it using a small screwdriver.

2. After the screw is removed (or if the transmitter has no screw), use a small coin or screwdriver to pry off the back of the transmitter to gain access to the battery.

3. Remove the battery, being very careful not to remove the transmitter circuit board.

4. Replace the battery. Be sure to observe the (+) and (-) signs in the battery compartment so the battery is installed with the proper polarity.
Replacement battery: Duracell-type MN21 or Gold Peak-type GP-23A or equivalent.

5. Replace the case backing and screw (if equipped), then verify that the keyless entry system operates properly. It is not necessary to reprogram the remote transmitter after changing the battery.