Codealarm RKE With Security System

(Port/Dealer installed - Not included in service manual) - 2002 Mirage (Optional) System Operation:

Operates the same as the CodeAlarm RKE Only system, except also provides siren, alarm, shock sensor and "panic" features. The status indicator light is also used as the alarm override button. Can be installed on vehicles without power door locks to function as just an alarm system.

When the system is armed, unlocking a door with the key will activate the alarm. To disarm and deactivate a system in this condition, press the UNLOCK button or simultaneously press the status indicator light and turn the ignition key to start the engine.

^ Arming: Press the LOCK button to arm the alarm and lock all doors. The parking lights will blink and the siren will chirp. When the system completes arming, the parking lights blink and the siren chirps again. A status indicator light will begin blinking.

^ Activating: If the alarm is armed, it is activated by either opening a door or by the shock sensor. The siren sounds and the parking lights flash. After a few minutes, the alarm deactivates and automatically re-arms itself. If the alarm has been activated, the status indicator light may blink faster.

^ Disarming: Press the UNLOCK button to disarm the alarm and unlock all doors. The parking lights blink, the siren chirps, and the dome light illuminates for 60 seconds or until the ignition key is turned to ON.

^ Deactivating: To deactivate the system without a transmitter, simultaneously press the status indicator light (which is also used as the alarm override button) and turn the ignition key to start the engine.

^ Panic Feature: Press both transmitter buttons simultaneously to activate the alarm.

NOTE:
Even if the system is not armed, the dome light illuminates for 60 seconds after the ignition key is turned to OFF

Receiver Module Location: Behind driver side front speaker

Ignition Switch Connection: 6-pin ignition switch connector on left side
of steering column

Parking Light Connection: GREEN/WHITE wire in 10-pin connector above the ignition switch connector in the parking light harness

Ground Connection: 10 mm bolt in left front kick panel area

Courtesy Light Connection: At ETACS unit in harness behind driver foot rest (NOTE: There are two wires of this color in the harness.)

Door Lock Connection: At ETACS unit connected to fuse block

CODEALARM (With Security) Transmitter Programming:

1. Turn the ignition key to the ON position.

2. Open the driver's door. (The courtesy light should come on.)

3. Press and hold the emergency override button (status indicator light). In 15 seconds the door locks should lock and unlock three times to indicate that you are in the programming mode. Continue holding the ignition override button.

4. Press the LOCK button on the new transmitter.

5. Release the ignition override switch.

6. Turn the ignition key to the OFF position.