Procedures

1. Do not immerse parts in cleaning solvent. Immersing the yoke and field coil assembly and/or armature will damage insulation. Wipe these parts with a shop towel only.
2. Do not immerse the drive unit in cleaning solvent. Overrunning clutch is pre-lubricated at the factory and solvent will wash lubrication from the clutch.
3. The drive unit may be cleaned with a brush moistened with cleaning solvent and wiped dry with a shop towel.

ASSEMBLY SERVICE POINT

Stop Ring/Snap Ring Installation:

>>A<< STOP RING AND SNAP RING INSTALLATION
1. Using a suitable pulling tool, pull the overrunning clutch stop ring over the snap ring.