Topstack Well

REMOVAL AND INSTALLATION

REMOVAL SERVICE POINT

[A] TOPSTACK WELL REMOVAL

NOTE: Before unstapling the old well, note the location and quantity of the staples.

1. At each end of the well, accurately mark the location of the well on the No.5 bow.
2. Using an awl, remove the well attaching staples.

INSTALLATION SERVICE POINT

]A[ TOPSTACK WELL INSTALLATION
Position and align the new well to the reference marks on the No.5 bow. Align the rear edge of the well to the bottom of the bow. Use 0.375 in. x 0.319 in. stainless steel, divergent point staples to secure it.